FoCom value setting module

The FCOM value setting module allows you to change the mileage shown on the instrument cluster to any desired value. The function is very easy to use: connect through the OBD2 connector to the instrument cluster, select coding functions -> Direct odometer change and enter the desired value. The whole thing is done through the OBD2 connector, there is no need to open the controllers and solder anything.

Note: It is not possible to change value settings through the OBD2 connector if your car is not listed and was manufactured before the models listed below (e.g. Mondeo 2001-2006, Focus up to 2003, etc.). Older gauge cluster modules do not have the ability to directly access memory through the OBD2 connector.

Important note: to use the FCOM value setting module, you must already have the FCOM diagnostic interface (supplied with the FCOM software). If you do not already have FCOM, please order it from us.

Legal Notice

The FCOM value setting module allows you to change a car's mileage both ways, up and down. This function is useful in many situations (usually when replacing the instrument cluster or engine), however, it can also be used for odometer/mileage changes (recalls), which are considered fraudulent in many countries (usually when a vehicle dealer falsely reports the actual mileage value of the vehicle to the buyer). FCOM users are not allowed to use the odometer correction function for fraudulent purposes. If this function is not allowed by the law in your country, you must not buy or install the FCOM module.