FiCom value setting module

The FiCOM value setting module allows you to change the mileage shown on the instrument cluster to any desired value. The function is very easy to use: connect via OBD2 to the instrument cluster, select coding functions -> odometer correction and enter the desired value. The whole thing is done through the OBD2 connector, there is no need to open the controllers and solder anything.

Only the ECUs listed above are supported.

Legal Notice

The FiCOM value setting module allows you to change a car's mileage both ways, up and down. This function is useful in many situations (usually when replacing an instrument cluster or engine), however, it can also be used for odometer/mileage changes (recalls), which are considered fraudulent in many countries (usually when a vehicle seller falsely reports the actual value of the vehicle's mileage to the buyer). FiCOM users are not allowed to use the odometer correction function for fraudulent purposes. If this function is not allowed by the law in your country, you must not buy or install a FiCOM module.