Dynotest BMW 6 Series F06, F12, F13 2011-2018

This device is specifically designed for testing BMW 6 Series F06, F12, F13 cars.
It provides the capability to temporarily suspend (freeze) the odometer during car testing, preventing the accumulation of additional mileage.

For more information, please visit the official product website: Dynotest

Pay attention!

The (BC) will not function properly because it cannot calculate values without having the mileage and it's NORMAL. When the device is activated, the on-board computer readings ("Average fuel consumption", "Current fuel consumption", "Fuel") and the navigation monitor ("On-board information" or "Trip computer", "Cruising range", "Distance to destination", "Fuel economy") will have incorrect values. After deactivating the device, you must RESET the on-board computer from the BC and the navigation menu. The BC will then start working correctly again.

Device:
It is not intended to be used on public roads.
It is not intended for registered cars.

The Plug&Play technology eliminates the need for soldering during installation.

Information about the operation modes of the device on BMW 6 Series F06, F12, F13: 
The hazard warning light on the dashboard will blink each time when the device switches between modes.

Mode 1

Press and hold the "BC" button for 10 seconds.
The hazard warning light will blink once.
The mileage block function will be not active.

Mode 2

Press and hold the "BC" button for 10 seconds.
The hazard warning light will blink twice.
The odometer will register 40 km for every 100 km driven.

Mode 3

Press and hold the "BC" button for 10 seconds.
The hazard warning light will blink three times.
The odometer will register 30 km for every 100 km driven.

Mode 4

ONLY for cars with software update BEFORE 2019.
Press and hold the "BC" button for 10 seconds.
The hazard warning light will blink four times.
The odometer will register 1-2 km for every 100 km driven.

Mode 5

Press and hold the "BC" button for 10 seconds.
The hazard warning light will blink five times.
The odometer will register 1-2 km for every 100 km driven.
In this mode speedometer will NOT show the actual speed.

Important for successful installation and use:

• During device connection/disconnection, the ignition must be turned off
• Switching between modes should be done on a stationary car
• When the device is in use, the selected mode will be retained (saved) after the ignition is turned off/on