Dynotest Audi A7, S7, RS7 2011-2016

Device:
It is not intended to be used on public roads.
It is not intended for registered cars.

The Plug&Play technology eliminates the need for soldering during installation.

Information about the operation modes of the device on Audi A7, S7, RS7: 
The hazard warning light on the dashboard will blink each time when the device switches between modes.

Mode 1

Press the "OK" button or pull HIGH BEAM lever 3 times.
The hazard warning light will blink once.  
The mileage block function will be not active.

Mode 2

Press the "OK" button or pull HIGH BEAM lever 3 times.
The hazard warning light will blink twice.
The odometer will register 50 km for every 100 km driven.

Mode 3

Press the "OK" button or pull HIGH BEAM lever 3 times.
The hazard warning light will blink three times.
The odometer will register 10 km for every 100 km driven.

Mode 4

Press the "OK" button or pull HIGH BEAM lever 3 times.
The hazard warning light will blink three times.
The mileage block function will be FULL active.

Important for successful installation and use:

• During device connection/disconnection, the ignition must be turned off
• Switching between modes should be done on a stationary car
• When the device is in use, the selected mode will be retained (saved) after the ignition is turned off/on.