DNTPSAV1 Dynotest Toyota Proace Verso 2016-2023

The device is compatible with:

• Toyota Proace Verso

It is not intended to be used on public roads.

The Plug and Play technology eliminates the need for soldering during installation.

Information about the operation modes of the device on Toyota Proace Verso car

The hazard warning light on the dashboard will blink each time the device switches between modes.

Mode 1

To activate this mode, pull the light signal toward you 4 times.
Upon activation, the hazard warning light on the dashboard blinks 1 time.
In this mode, the mileage block function is not active.
The odometer works normally.
The speedometer will display the actual speed.

Mode 2

To activate this mode, pull the light signal toward you 4 times again.
Upon activation, the hazard warning light on the dashboard blinks 2 times.
After that, the odometer will record 10 kilometers for every 100 kilometers driven.
The speedometer will display the actual speed. 

Mode 3

To activate this mode, pull the light signal toward you 4 times again.
Upon activation, the hazard warning light on the dashboard blinks 3 times.
After that, the odometer will record 1 kilometers for every 100 kilometers driven.
The speedometer will display the actual speed. 

Mode 4

To activate this mode, pull the light signal toward you 4 times again.
Upon activation, the hazard warning light on the dashboard blinks 4 times.
After that, the odometer will stop recording.
The speedometer will display the actual speed. 

IMPORTANT FOR SUCCESSFUL INSTALLATION AND USE:

• During device connection/disconnection, the ignition must be turned off.
• Switching between modes should be done on a stationary car.
• When the device is in use, the selected mode will be retained (saved) after the ignition is turned off/on.