DNTFORD2 DYNOTEST Ford Ranger 2015+

To activate this mode, pull the high beam switch toward you three times.
When activated, the hazard lights on the dashboard will flash once.
In this mode, the mileage lock function is not active.

Mode 2

To activate this mode, pull the high beam switch toward you three times.
When activated, the hazard lights on the dashboard will flash twice.
The odometer will then register 50 kilometers for every 100 kilometers traveled, and the speedometer will display the actual speed.

Mode 3

To activate this mode, pull the high beam switch toward you three times.
From then on, the odometer will count down 10 kilometers for every 100 kilometers traveled,
and the speedometer will indicate the actual speed.

Mode 4

To activate this mode, pull the high beam switch toward you three times. 
The hazard lights on the dashboard will flash 4 times.
From this point on, the odometer will be stopped - the mileage lock function is activated;
the speedometer will indicate the actual speed.

Important information on installation and use

• When connecting/disconnecting the device, the ignition must be turned off.
• Switching between modes should be done in a standing car.
• The selected mode will be retained (saved) when the ignition is turned off/on.

Instructional video: