Dynotest Jeep Renegade 2014+

This device is specifically designed for testing Jeep Renegade cars.
It provides the capability to temporarily suspend (freeze) the odometer during car testing, preventing the accumulation of additional mileage.

For more information, please visit the official product website: Dynotest

Device:
It is not intended to be used on public roads.
It is not intended for registered cars.

The Plug&Play technology eliminates the need for soldering during installation.

Information about the operation modes of the device on Jeep Renegade: 
The hazard warning light on the dashboard will blink each time when the device switches between modes.

Mode 1

Pull the HIGH BEAM lever 4 times.
You will hear sound signal once.
The mileage block function will be not active.

Mode 2

Pull the HIGH BEAM lever 4 times.
You will hear sound signal twice.
The odometer will register 50 km for every 100 km driven.

Mode 3

Pull the HIGH BEAM lever 4 times.
You will hear sound signal three times.
The odometer will register 10 km for every 100 km driven.

Mode 4

Pull the HIGH BEAM lever 4 times.
You will hear sound signal four times.
The mileage block function will be FULL active.

Important for successful installation and use:

• During device connection/disconnection, the ignition must be turned off
• Switching between modes should be done on a stationary car
• When the device is in use, the selected mode will be retained (saved) after the ignition is turned off/on

How to install: