Dynotest for Mitsubishi Outlander 2021-2023

The device is compatible with:

• Mitsubishi Outlander 2021-2023

It is not intended to be used on public roads.

The Plug and Play technology eliminates the need for soldering during installation. 

Information about the operation modes of the device:

The hazard warning light on the dashboard will blink each time the device switches between modes.

Mode 1

To enter mode 1 pull the High Beam lever 4 times.
The hazard warning light on the dashboard will blink 1 time.

In mode 1, the mileage block function is inactive, so your kilometers are recorded at 100%.

Mode 2

To move to mode 2, pull the High Beam lever again.
The hazard warning light on the dashboard will blink 2 times.

In mode 2, only 50% of the actual mileage is recorded.

Mode 3

To switch to mode 3 pull the High Beam lever 4 times.
The hazard warning light on the dashboard will blink 3 times.

In mode 3, only 10% of the actual mileage gets recorded.

Mode 4

For mode 4, pull the High Beam lever 4 times again.
The hazard warning light on the dashboard will blink 4 times.
In mode 4, the mileage block function is fully active, so 0% of the actual mileage is recorded.

Important for successful instalation and use:

• During device connection/disconnection, the ignition must be turned off.
• Switching between modes should be done on a stationary car.
• When the device is in use, the selected mode will be retained (saved) after the ignition is turned off/on.