DNTBMWG Dynotest BMW X4 G02 2018-2023

The device is compatible with:

• BMW G02 X4 2018+

It is not intended to be used on public roads.

The Plug and Play technology eliminates the need for soldering during installation.

Information about the operation modes of the device on BMW cars.

The hazard warning light on the dashboard will blink each time the device switches between modes.

Mode 1

In this mode, the mileage block function is not active.

Mode 2

To activate this mode, press and hold the "BC" button for 3 seconds.
Upon activation, the hazard warning light on the dashboard will blink twice.
After that, the odometer will record 50 kilometers for every 100 kilometers driven, and the speedometer will display 50% of the actual speed.
Use this mode for cars equipped with the 2018+ software update. 

Mode 3

Press and hold the "BC" button for 3 seconds.
The hazard warning light on the dashboard will blink 3 times.
After that, the odometer will record approximately 1 kilometer for every 100 kilometers driven, and the speedometer will show the actual speed.
Use this mode for cars with the 2018+ software update.

Mode 4

Press and hold the "BC" button for 3 seconds.
The hazard warning light on the dashboard will blink once.
The odometer will stop, and the speed indicator will show the actual speed.
ONLY for cars with software update before 2018. 

Bypass
Press and hold the “BC” button for 3 seconds.
The hazard warning light on the dashboard will blink 4 times.
The odometer and speedometer will operate as normal, as if the device were not installed.

EXPLANATION
The (BC) will not function properly because it cannot calculate values without having the mileage and it’s NORMAL. When the device is activated, the on-board computer readings (“Average fuel consumption”, “Current fuel consumption”, “Fuel”) and the navigation monitor (“On-board information” or “Trip computer”, “Cruising range”, “Distance to destination”, “Fuel economy”) will have incorrect values. After deactivating the device, you must RESET the on-board computer from the BC and the navigation menu. The BC will then start working correctly again.

Adaptive cruise control and radar work in all modes! 

IMPORTANT FOR SUCCESSFUL INSTALLATION AND USE

• During device connection/disconnection, the ignition must be turned off.
• Switching between modes should be done on a stationary car.
• When the device is in use, the selected mode will be retained (saved) after the ignition is turned off/on.

How-to video coming soon!