T-CAN Tool for Tesla cars
Diagnostic and Programming Tool
for TESLA Car Model S, X and 3
T-CAN PRO has very fast developing software and hardware with small box interface. Can help you solve many problems with the TESLA car "Model S, X and 3".
T-CAN PRO can work with ECU TESLA Model S,X,3
- 2019.05.23 NEW SDM by BOSH Module X and 3 model (read,clear fault codes and R/W EEPROM clear CRASH log.)
- ALERTS – Alerts on CAN bus (read alerts codes updated BMS 2018.09.14 BETA STAGE !)
- BDY - Body controller on CAN bus
- DH - Door Handles - Learn Front Driver Side - CAN BDY -125 kbps (BETA Stage - added 15.07.2019)
- SDM – Supplemental Deployment Module S model (read,clear fault codes,clear CRASH log by Boot mode pin.)
- SDM by BOSH Module X and 3 model (read,clear fault codes and R/W EEPROM clear CRASH log.)
- SEC – Security controller (Add Keyfob Key)
- CP – Charging port.
- PARK2 – Parktronic sensors (read and decode fault codes,erase stored fault codes)
- THC – Thermal controller (Airpurge function)
- EAS-TAS – Tesla Airsuspension System (read,decode,erase fault codes,clear Crash event, exit service mode ) supported until 06.2016
- BMS – Battery control Module (reset alert warnings w163,w026,w152,w153,w023,read softpack)
- TPMS – Tyre Pressure (read sensor ID stored in memory it usefull if you need to make new non tesla sensor)
- ESP – Electronic stability system (read and decode fault codes,erase stored fault codes)
What is T-CAN ?
T-CAN PRO is hardware and software for Tesla car only
The software is nessesrey to work with harware !
H A R D W A R E
1. Car Programmer – plastic blue box with info label on top, inside is PCB (Printed Circuit Boards with semiconductors and SIM card). The device does not contain batteries
2. 2 Data cables (type: x437 and x437A) - these 2 cables are used to connect the car to the programmer
3. USB cable – this cable is using to connect the programmer to the PC or Laptop
S O F T W A R E
The software you need to work with T-CAN PRO programmer.
There is no other software.
The software is frequently updated, so it is recommended to check from time to time [ T-CAN PRO - DOWNLOAD SECTION ] to see if new software is available.
To buy the software you need to select it as an option
T-CAN PRO software screenshots
N O T I C E R E G A R D I N G S O F T W A R E
W A R N I N G !
DON'T BUY T-CAN PRO IF
R E T U R N
S U P P O R T !
Connector x437 or x437A (female) has to be plug into Tesla Diagnostic Connector (male)
If you do not know where is Diagnostic Connector, take a look on video below between 49 sec. - 1.10 mins.:
Work on the bench while developing the T-CAN tool